Fsbuild-2 Flight Planner

Hi Ernie,

I haven't used FSBuild for a while but recently started it up again. I am having a problem with this route.

YPPH-YSSY
DCT PH H18 BURGU Y135 YORKE J15 AD H247 CULIN Y59 SY DCT

FSBuild doesn't seem to recognise the H18 or the Y135 airway despite me being able to find them in the awys.txt file (I cannot find them in the fsb_awys.txt file). I have updated to v2.3.1 and AIRAC 1105 from Navigraph. Also the Departure procedures for YPPH and YSSY are out of date. Did I miss a step somewhere?

v2.3.1 does not use AIRAC 1105.

Did you read the topics at the top of this FSBuild 2 Support forum?

_________________
Vaughan

Hi von,

Thanks for the info. I don't know what topics I am supposed to have read, all I did was a search for updating navdata which revealed a post from 2005 and wasn't really relevant to my problem. All I see is a topic relating to a beta release v2.4 that I do not have, why would I read that for a problem relating to v2.3.1. If I am supposed to have that version of the software I apologise however that version of the software is is not the retail version and not what is linked from the main FSBuild site.

If v2.3.1 is not supported by Navigraph then why is there a link to the navigraph data from the FSBuild site stating "FSBuild v2.3 navdata (navigraph)'?

Sorry if I am wasting time here but it's rather annoying to be expected to read an entire message board when an FAQ and a search for a keyword doesn't reveal the answer to my problem. Not everyone can be following every single bit on software on the net at all times, if they did there would be no time left for simming, would there?

Are you saying I should get the pre-release beta and use the new navdata on that?

Thanks

Hi barbs,

Yes, that's what von is suggesting. If you want to use updated AIRACs (Navigraph) you have to download and install the updated version v2.4.0.18
You can find instructions on how to install and link to download in this thread (the first post).

viewtopic.php?f=1&t=3630

If you by any chance wants to keep the official v2.3 you won't be able to use the new AIRACs.

best regards,
Igor