Fsbuild-2 Flight Planner

Ok a strange one this which I cant understand.

Im running version 2.4.0.18

I load the aircraft as the B737-800 w/CFM-7B26

On the aircraft page I change the values to KGS I have a empty weight of 41413 and Payload of 19911

For Dep I put in EGPH runway 24 DCS4C sid Arrival is EGLL 27R BNN1B

Flightplan is thus DCS4C UN615 LAKEY NUGRA BNN1B

When I ask FSbuild to build this it does fine - however when I go to the NAVlog page this is whats produced

TAXI 000113 0010 . . . . 857796307 064648 M001
DEST EGLL 857731659 0050 . . . . ELEV. 83 FT
RESV 002462 0045 . . . .
ALTN 000861 0016 . . . . ALTN EGKK DIST 22
HOLD 000000 0000 . . . .
EXTRA 000000 0000 . . . . ZFW 061324 PAYLOAD 019911
TTL AT TO 857734983 0151 . . . . DIST 0330
REQD 857735097 0201 . . . . ETD


As you can see the fuel figures are corrupt - Now for the extra weird bit - If I do the build again but leave the wight as Lbs instead It gives correct figures - to add to the weird factor if i build a route to anywhere else in the world using method as above of changing figures to KGS it builds fine with no corruption at all.

Any clues on this one?

any update or ideas on this? whenever i plan into heathrow i get this corrupt data

Must be a problem with the conversion to KGS, cause it works fine in LBS, or if the weights were in KGs to begin with.

All I can do is put it on the to-do list for a future update.

Regards.
Ernie.

Yes what is weird is that it only ever occurrs when the destination is EGLL. I can plan into any airport in the world, using either KGS or lbs and it works fine every time. Soon as I put EGLL as the destination, then if I select KGS then it gives the corrupt fuel weight figures.