Fsbuild-2 Flight Planner

Hello,
I have FS2004, FSBuild 2.3 and CS757. I use FSBuild to create the flight plans which I have it set up to save the plan on FS2004. However when I try to import the flight plans using CS757 FMC all I get is LAT/LONG rather than the names of the way points. This only happens when I use FSBulid to create the flight plan. If I create the flight plan using the native FS2004 flight planner the plans import well to CS757 with the names of the waypoints.

Is there a way to correct this situation?

Thank you!

Hello again,
I figure it out! Here are the steps:
1. Create flight plan using FSBuild and save flight plan in FS2004.
2. Open FS2004
3. Open FS2004 native flight planner and select the desired flight plan (created in step 1)
4. Save the plan again via FS2004 using the same name and overwriting the existing one.
5. Open CS757 and import via the FMC.

The waypoints will be listed by names rather than by LAT/LONG.