Fsbuild-2 Flight Planner

Hi Everyone,
I am new to this forum, long time user of ISG software, and fairly proficient in add on installation. I recently started using isg in FSX mostly in TM 737_200ADV. I have also upgraded to v 1.8. I installed a retrofit for the TM 737-200ADV from the ISG Website and it worked fine. I then decided to add the P1000 MFD to the cockpit, but my problem is getting the P1000_MFD_OPEN Icon to show up on the panel. I did the install in accordance with the ISG settings doc, also verified it with other retrofit files with the P1000 mfd and my FS9 Tinmouse installation. Everything looked fine on paper except the Icon wont show up on the panel in FSX.

Can some on please please help me, what did I do wrong?
Thanks in advance.

Attached is a image of Panel CFG.

I suspect its in a position another gauge is in. Its important to know that in FSX, xml gauges have a higher priorirty than C++ gauges (which ISG is).

If there is a xml gauge in the same location in the panel as the ISG gauge, it will effectively hide the ISG gauge from view in the panel.

Hi Ernie,
thanks for replying to my post. After clearing my mind for some hours, I went back to do a detail line by line scrutiny of the panel cfg file, side by side with Fs9 TM737 copy. I started from the top, when I reached [Window00] gauge 30 I found gauge 31 had been commented out and the next gauge started with #32 instead of #31 as shown below in the sample of the Fs9 TM737 panel cfg file. I then put the line numbers in sequence,save and reload FSX TM 737-200. The P1000 MFD OPEN Icon showed up where it had put it.

---------------------------Panel Cfg file ------------------------------------------------
gauge30=B732ADV!hsi, 185, 795, 187, 167 //Mechanical HSI

//gauge31=B732ADV!fd_cont, 709, 372, 174, 101 //disable when SP177 equipped

gauge32=B732ADV!oil_qty_1, 950, 786, 80, 78
-----------------------------------------------------------------------------------------

Thanks again for taking a look at my post, happy weekend.