See the thread below regarding the Simcheck A300 and iSG1.
http://www.fsbuild.com/forum/viewtopic. ... eck#p12185It does make things easier if you understand panel.cfg settings as every aircraft is different.
We have provided a library of ready to use panel retrofits on the library/retrofit page at isgsim.com.
But if you plan on installing it on aircraft we did not make a retrofit for, then yes it will
be a bit difficult if you know very little or nothing about installing gauges or panels.
However we will assist you in doing so if that ends up being the case.
Regards.
Ernie.[/quote]
Thanks Ernie, so I can just cut and paste the retrofits into the panel.cfg file? Assuming that I am only going to add these to aircraft that retrofits are available for (I saw several I have at the link you provided), you are saying that setup is pretty easy? I just want to make sure that I am not pulling my hair out of my head when trying to configure the panels, but if all I need to do is change my panel.cfg to look like the ones at the retrofit library, and seems fairly straight forward. Thanks again for your assistance.
Cheers, Pete