Fsbuild-2 Flight Planner

Hallo,

last week i installed the Isg panels 1.8.0 version.
After installing the retrofit B737 panel for the default B737-400 in fs9 many problems occure.
Not possible to start B737 direct from ksea (default) fs9 is hanging.
Only after starting first the cessna and the selecting the B737 will start/open.
But after stopping Fs9 (Ctrl +C) and restart Fs9 again a message appear that Fs9 is still running!!!
I removed the isg panel.cfg from the B737 and the problem was solved.

After reading the forum i found that there are several familiar problems with the Default B737 isg panel.
But i did,t find any solution for this problem yet?

So my question is, are there solutions for this problem.

I also use the overland MD11 and default B777 isg panel without any problems

rgds Willem.