Fsbuild-2 Flight Planner

Just purchased your wonderful program and the Virtavia C-17. Last night while flying C-17 I noticed the engine indications where mis-matched w/ throttles. I use FSUIPC and eg. throttle 1 indications showed on throttle 2 and vice versa 2 for 1 and same w/ 3 and 4. I don't think this was going on prior to installing ISG. Can you shed any light on this?

I also see the Smith FMC is in use rather then the C-17 FMC spoken about some time ago. Did something change w/ plans to add this FMC? Thank you for your assistance


I pretty sure the ISG program is the problem....removed FSUIPC settings and re-installed C-17 w/out ISG, all was fine. Loaded ISG and the problem re-appeared. The Number 2 throttle was number 1 throttle on the engine EPR Bar gage. I am using FS9.1

The problem I have described exists and is only corrected when removing the ISG panel. I have the Virtavai C-17, using W7 64

Thank you for your response, look forward to the correction . As for the FMC, I can understand, still wish for the other.
You are correct 3/4 are okay w/ me too, just 2 and 1 or 1 and 2 LOL

Thank you again